2014 Formula One Power Unit Regulations

What are the components of a capacitive power supply?

Full-wave bridge rectifier circuit. Voltage regulator circuit. Power indicator circuit. A capacitive power supply has a voltage dropping capacitor (C1), this is the main component in the circuit. It is used to drop the mains voltage to lower voltage. The dropping capacitor is non-polarized so, it can be connected to any side in the circuit.

What is the relationship between charge current and supply voltage?

The relationship between this charging current and the rate at which the capacitors supply voltage changes can be defined mathematically as: i = C (dv/dt), where C is the capacitance value of the capacitor in farads and dv/dt is the rate of change of the supply voltage with respect to time.

How to calculate capacitance of a capacitor?

The following formulas and equations can be used to calculate the capacitance and related quantities of different shapes of capacitors as follow. The capacitance is the amount of charge stored in a capacitor per volt of potential between its plates. Capacitance can be calculated when charge Q & voltage V of the capacitor are known: C = Q/V

What happens when a capacitor reaches a peak?

The voltage across the capacitor matches the power supply voltage, so the current is large to build up charge on the capacitor plates. The closer the voltage gets to its peak, the slower it changes, meaning less current has to flow. When the voltage reaches a peak at point b, the capacitor is fully charged and the current is momentarily zero.

How do you calculate the charge of a capacitor?

C = Q/V If capacitance C and voltage V is known then the charge Q can be calculated by: Q = C V And you can calculate the voltage of the capacitor if the other two quantities (Q & C) are known: V = Q/C Where Reactance is the opposition of capacitor to Alternating current AC which depends on its frequency and is measured in Ohm like resistance.

What type of power supply uses a capacitive reactance?

This type of power supply uses the capacitive reactance of a capacitor to reduce the mains voltage to a lower voltage to power the electronics circuit. The circuit is a combination of a voltage dropping circuit, a full-wave bridge rectifier circuit, a voltage regulator circuit, and a power indicator circuit.